The data set to be stored depends on the type of subscriber:

• For a public IP address, exporting Full NetFlow to QoE Stor is sufficient. Configuring export in IPFIX (Netflow 10)
• For a private IP address, additional NAT Flow data collection — translation information — is required. NAT Flow Configuration

Information is searched through aggregated data. Initially, SSG exports raw data to QoE Stor, and by default, aggregation is performed every 15 minutes. More on changing aggregation and re-aggregation intervals.

Raw unaggregated data is available in the following sections of QoE Analytics in the GUI:

1. Raw Full NetFlow (by default, data is stored for 2 hours)
2. Raw NAT Flow (by default, data is stored for 2 hours, QoE license required)

Aggregated statistics are available in the following sections of QoE Analytics in the GUI:

1. NetFlow (by default, data is stored for 14 days)
2. NAT Flow (by default, data is stored for 14 days, QoE license required)

In the GUI, go to Administrator → GUI Configuration → Settings → QoE Stor: Database Lifetime Settings:

• For Raw Full NetFlow, select Lifetime of fullflow QoE Stor log in hours (1).
• For NAT Flow, select Lifetime of aggregated NAT QoE Stor log in days (2).

When increasing the data retention period, it's recommended to enable the deletion of old data when the disk fills up: Administrator → GUI Configuration → Settings → QoE Stor: Disk Settings → Select Enable forced data migration… – choose Enable data deletion! → Select Migration coefficient for the DEFAULT disk… – set the value to 0.1.

You can find out how much disk space logs are using in QoE Analytics → Administrator → Reports → Table Space Information.

The ability to view subscriber activity data appears after generating the NAT log — instructions Конфигурация NAT Flow.
In the GUI, navigate to QoE Analytics → NAT Flow.
In the NAT Flow section, you need to:

1. Select the time period
2. Enable the “IPv4 source address” and “IPv4 destination address” filters (check the box)
3. Enter values for the enabled filters and apply changes

In the GUI, navigate to QoE Analytics → NetFlow.
In the NetFlow section, you need to:

1. Select the time period (by default stored for only 14 days!)
2. Enable the “Subscriber,” “Login,” and “Host IP” filters (check the box)
3. Enter values for the enabled filters and apply changes

In the GUI, navigate to QoE Analytics → Raw Full NetFlow.
In the Raw Full NetFlow section, you need to:

1. Select the time period (by default stored for only 2 hours!)
2. Enable the “IPv4 source address” and “IPv4 destination address” filters (check the box)
3. Enter values for the enabled filters and apply changes