(SPAN ports or optical splitter)

When detecting a blocked url VAS Experts DPI sends HTTP redirect to browser WEB page with information about blocking.

• Destination MAC - routers' MAC of port where outgoing link is pluged in
• Source MAC - out_dev NICs' MAC
• Source IP - IP of blocked host (IP2)
• Destination IP - users' IP (IP1)

VLAN can be keeped or cleared by configurable parameter.

To IP2 (blocked host) sending a packet with TCP RST for connection reset. Blocking (HTTPS) and redirecting (HTTP) ocures because of difference in response time between VAS Experts DPI and blocked host. VAS Experts DPI is close to users' IP1 then blocked IP2.

Router port where VAS Experts DPIs' outgoing link is pluged in has to be L3 mode as usual. Main task is receive packet from VAS Experts DPI and route it by subscrider by general routing tables.

Config sample for Juniper: eth1 is pluged in to Juniper MX Juniper MX settings:

 description from_SKAT_redirect;
 unit 0 {
 family inet {
 address a.b.c.d/30;
 }
 }

Change the settings by editing the configuration file /etc/dpi/fastdpi.conf.

Let VAS Experts DPI be connected as follows:

dna1,dna2,dna3 - receive the mirrored traffic
dna0 - is connected to the router that receives and redirects subscribers' queries and to Internet

One has to configure DPI for mirrored traffic processing as follows:

First, assign the input ports that receive the mirrored traffic to in_dev:

in_dev=dna1:dna2:dna3

Second, assign the ports that get the redirection request to tap_dev:

tap_dev=dna0

Enable asymmetric mode:

asym_mode=1

Set direction of replies tap_dev:

emit_direction=2
tap_mode=2

Set to clear VLAN in outgoing packets:

strip_tap_tags=1

And configure MAC replacement:

replace_source_mac=00:25:90:E9:43:59 - MAC address of out_dev card: dna0
replace_destination_mac=78:19:F7:0E:B1:F4 - the router port MAC address that has a general routing table

Set number of packets repeats, for unstable delivery in networks:

emit_duplication=3 
here 3 - number repeats of packets with redirection or RST (dublicates packets send with RST or redirection) 

It is advised to use an additional 1GbE network card to send the replies in mirrored traffic mode. For example, intel i350 (with DNA license) can be used. This allows to configure an individual port for sending redirection replies and to reserve 10GbE ports to receive the mirrored traffic.

Mirror scheme installation manual