====== DPI configuration ======
{{indexmenu_n>4}}

== Export setting ==

Platform DPI version not lower than 8.1.

The ipfix export can be configured by directly editing the fastdpi.conf file on DPI.

<code>
netflow=8
netflow_dev=em1
netflow_timeout=10
netflow_full_collector_type=2
netflow_full_port_swap=0
netflow_full_collector=YOUR_QOESTOR_IP:1500
ipfix_dev=em1
ipfix_tcp_collectors=YOUR_QOESTOR_IP:1501
</code>

**You will need to restart fastdpi for the changes to take effect.**

**Note that the netflow parameter is a bit mask. Allows several different values. For more details see here [[en:dpi:dpi_options:opt_statistics:statistics_settings:start|Configuring IPFIX export]]**

Also you can do customization using DPIUI2 - [[en:dpi:dpi_components:dpiui:start|dpiui2 ]]. Dpiui2 version must be at least 2.1.0.

To configure using DPIUI2, go to DPI Control -> Configuration. Open the Collect and analyze statistics by protocols and directions tab.

Set the neflow parameter to Export full session statistics. See fig. below.

{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi.png?400 |}}

Enter the receiver's fullflow socket in the netflow_full_collector parameter. The netflow_full_collector_type parameter must be set to "Export ipfix to udp collector" and leave the netflow_full_port_swap parameter empty or equal to "Keep original port numbers". See fig. below.

{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_1.png?400 |}}

Enter the receiver's clickstream socket in the ipfix_udp_collectors parameter. See fig. below.

{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_2.png?400 |}}

Click Save. Restart fast_dpi. See fig. below.

{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_save_restart.png?400 |}}


== Assigning a DPI number ==

Open the Hardware Management -> Hardware section. For each device, enter an Id on the ipfix collector. See fig. below.

{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_set_dpi_num.png?400 |}}

=== Configuring DPIUI2 connection to QoE Stor ===

To view QoE reports, you need to configure DPIUI2 connection to QoE Stor. See section [[en:dpi:dpi_components:dpiui:configuration:start|Configuring connection to QoE Stor]]