Differences

This shows you the differences between two versions of the page.

--- en:dpi:dpi_options:opt_priority:priority_settings:start [2023/10/10 08:25] – external edit 127.0.0.1
+++ en:dpi:dpi_options:opt_priority:priority_settings:start [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== Configuration ======
-{{indexmenu_n>2}}
-The option is configured or disabled by editing the configuration file **/etc/dpi/fastdpi.conf**.
-<note warning>This is a cold parameter which requires restart of service!</note>
-Enable prioritizing markup of a traffic on level:
-<code>
-set_packet_priority=1
-</code>
-  * 1 - IP header
-  * 2 - VLAN/QinQ header
-  * 3 - MPLS header
-<note important>set_packet_priority=1 leads to patching of all packets that pass through DPI to set the priority in their headers. This operation takes a lot of resources. Therefore do not switch this flag on until you do not need to use these modified priorities on other network devices.</note>
-Configuration parameters from [[en:dpi:dpi_options:opt_priority:priority_config:start|Assignment of priorities]] are sufficient for internal DPI usage.

Profile