Configuration [Документация VAS Experts]
Документация VAS Experts Документация VAS Experts-mobile
in

Settings

  • Show page
  • Old revisions
  • Export to PDF
  • Fold/unfold all
  • Backlinks
  • Show page
  • Old revisions
  • Export to PDF
  • Fold/unfold all
  • Backlinks

    • Differences

    This shows you the differences between two versions of the page.

    Link to this comparison view

    Both sides previous revisionPrevious revision
    Next revision    		Previous revision
    en:dpi:dpi_options:opt_priority:priority_settings:start [2020/02/05 17:30] – ↷ Links adapted because of a move operation lexx26en:dpi:dpi_options:opt_priority:priority_settings:start [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
    Line 1: Line 1:
    -====== 2 Configuration ====== 
    -{{indexmenu_n>2}} 
    -The option is configured or disabled by editing the configuration file **/etc/dpi/fastdpi.conf**. 
      
    -<note warning>This is a cold parameter which requires restart of service!</note> 
    -  
    -Enable prioritizing markup of a traffic on level: 
    - 
    -<code> 
    -set_packet_priority=1 
    -</code> 
    - 
    -  * 1 - IP header 
    -  * 2 - VLAN/QinQ header 
    -  * 3 - MPLS header 
    - 
    - 
    -<note important>set_packet_priority=1 leads to patching of all packets that pass through DPI to set the priority in their headers. This operation takes a lot of resources. Therefore do not switch this flag on until you do not need to use these modified priorities on other network devices.</note> 
    - 
    -Configuration parameters from [[en:dpi:dpi_options:opt_priority:priority_config:start|Assignment of priorities]] are sufficient for internal DPI usage.