1. ''dpdkinfo'' — receive diagnostic data from SFP modules. Parameters:
-
* ''-h'' – help
-
* ''module_eeprom'' – SFP module optical diagnostics information (if supported by the module).
-
-
2. ''bpctl_util'' — manual bypass control. DPI controls bypass independently, but manual bypass control is performed by this utility if necessary:
-
* ''get_bypass'' – get bypass status
-
* ''set_bypass on'' – activate bypass
-
* ''set_bypass off'' – deactivate bypass
-
-
3. ''driverctl'' — DPDK management. Parameters:
-
* ''list-overrides'' – check the list of cards in DPDK mode
-
* ''unset-override 0000:04:00.0'' – exit the card from the DPDK mode\\ **The fastDPI process must first be stopped with the command ''service fastdpi stop''!**
-
* ''-v set-override 0000:04:00.0 vfio-pci'' – return the cards back under DPDK control after working with the standard driver\\ **When switching cards to DPDK mode, be careful not to accidentally switch the server control interface to DPDK mode - communication with the server will be immediately interrupted!**
-
-
<note>Configuring DPDK in Hyper-V is described in detail in the appropriate [[en:dpi:dpi_components:platform:dpi_config:start#configuration_in_hyper-v|section]].</note>
-
-
4. ''checklock'' — check if an address or port is blacklisted.\\ Example of a port check:
-
<code bash>checklock 41:00.0</code>
-
-
5. ''checkproto'' — check if the address or port is included in the custom protocol.\\ Example of a port check:
