| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| en:dpi:dpi_components:qoestor:install_and_update:install [2023/08/31 09:01] – elena.krasnobryzh | en:dpi:dpi_components:qoestor:install_and_update:install [2025/10/01 12:21] (current) – elena.krasnobryzh |
|---|
| ====== install ====== | ====== QoE Stor installation ====== |
| | {{indexmenu_n>3}} |
| | |
| | <note warning>Before installing or upgrading, check your Internet connection. Make shure you run scripts under the root or using sudo.</note> |
| | |
| | <note warning>Check if the time and time zone are set correctly on the server. Correct and restart the server if necessary.</note> |
| | |
| | <note warning>Do not disable the standard firewall-cmd. The installation script uses it for self-configuration.</note> |
| | |
| | <note warning>Do not use the yum update fastor command. Install/update with the script below.</note> |
| | |
| | <note warning>Enable IPv6. If the database doesn't start after installation, the most likely reason is IPv6. Check the error log: tail /var/log/clickhouse-server/clickhouse-server.err.log - the cause is usually clearly indicated there.</note> |
| | |
| | For automatically installation or upgrading follow these steps: |
| | |
| | - Execute [[https://vasexperts.ru/install/fastor-rpm_install.sh|fastor-rpm_install.sh]] script. <code> |
| | source <(curl https://vasexperts.ru/install/fastor-rpm_install.sh) |
| | </code> It will cause the installation of the following packages: ipfixreceiver, clickhouse, fastor. All of them will be automatically configured according to the defaults. |
| | - Restart your ssh terminal. You need to make command aliases available. |
| | - Run the command <code> fastor-db-scheme </code> The database schema will be updated. |
| | <note important>In some systems, the database starts very slowly (from several minutes to several tens of minutes, especially in systems with long-term data storage) and when updating you may receive an error like **ERROR: while updating DB scheme**\\ |
| | {{:dpi:dpi_components:qoestor:dbcheme_update_err.png?600|}} |
| | |
| | Wait for the database to start. You can check the tail /var/log/clickhouse-server/clickhouse-server.log logs, or simply try to launch the clickhouse-client client - if there is a connection, then the database has started and is ready for connections. |
| | |
| | After starting the database, run the command <code>fastor-db-scheme</code> |
| | </note> |
| | <note important>Do not forget to execute <code>fastor-db-scheme</code> after installation. This insures cases when the schema does not have time to update as a result of a long restart of the database. </note> |
