en:dpi:dpi_components:qoestor:hardware_recommendations:start [Документация VAS Experts]

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
en:dpi:dpi_components:qoestor:hardware_recommendations:start [2021/08/05 15:53] arusnaken:dpi:dpi_components:qoestor:hardware_recommendations:start [2021/08/05 16:36] (current) – removed arusnak
Line 1: Line 1:
-===== 2 Equipment prerequisites ===== 
-{{indexmenu_n>2}} 
- 
-<note important>Do not install the module on the same server with the DPI platform!</note> 
- 
-=== Minimum requirements === 
- 
-For the subsystem, you can use hardware or virtual machines with the characteristics listed below: 
-  - Processor (CPU) 2.5 ГГц - 1 pce 
-  - RAM - at least 16 GB 
-  - Hard disk drive (SSD is highly desirable) - at least 500 GB 
-  - Operating system - CentOS 7+ or CentOS 8+ 
-  - Network interface (NIC) - at least 1 Gbps 
-<note important>{{ :dpi:dpi_components:capacity_space_for_qoe_and_hardware_example.xlsx |Capacity space for QoE and Hardware example}}</note> 
- 
-== Processor == 
- 
-SSE 4.2 instruction set support is required. 
- 
-Choose processors with a large number of cores. Clock frequency is less important. For example, 16 cores with 2,600 MHz are better than 8 cores at 3,600 MHz. 
- 
-<note important>Do not disable Hyper-threading and Turbo-Boost.</note> 
- 
-== RAM == 
- 
-RAM should be no less than the amount of data requested. 
- 
-The more RAM server has, the better performance will be achieved when building reports. 
- 
-The more memory, the less disk system is stressing. 
- 
-Minimum prerequisites is 16 GB. 
- 
-Always disable the swap file. 
- 
-== Disk == 
- 
-Required disk space is at least 16 GB for every storage day, it's actual value depends on daily traffic. It is estimated that 10 Gbit/s of average daily traffic generates approximately 25 GB of data per hour in the QoE Store. 
- 
-If your budget makes you possible to use SSD, use it. Otherwise use HDD. SATA HDDs 7200 RPM will be suitable. 
- 
-When using HDD, you can combine them into RAID-10, RAID-5, RAID-6 or RAID-50. 
- 
-Most of the data is stored in the ''/var/lib/clickhouse/'' directory. You can mount a drive/partition on this directory. 
- 
-Temporary data (ipfix dumps) is stored in the ''/var/qoestor/backend/dump/'' directory. 50 GB be sufficient for this. 
- 
-For best performance, it is important (recommended) that these directories are on a separate disk or array. See [[en:dpi: dpi_components: qoestor: configuration: disc: start | Disk space settings]]  
- 
-=== Maintenance advice from Yandex ClickHouse === 
- 
-You could familiarize yourself with the contents of maintenance advice from Yandex ClickHouse by following the [[https://clickhouse.yandex/docs/en/operations/tips/|https://clickhouse.yandex/docs/ru/operations/tips/]] link. 
-