Differences

This shows you the differences between two versions of the page.

--- en:dpi:dpi_components:qoestor:configuration:dpi:start [2023/09/06 14:36] – elena.krasnobryzh
+++ en:dpi:dpi_components:qoestor:configuration:dpi:start [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== DPI configuration ======
-{{indexmenu_n>4}}
-== Export setting ==
-Platform DPI version not lower than 8.1.
-The ipfix export can be configured by directly editing the fastdpi.conf file on DPI.
-<code>
-netflow=8
-netflow_dev=em1
-netflow_timeout=10
-netflow_full_collector_type=2
-netflow_full_port_swap=0
-netflow_full_collector=YOUR_QOESTOR_IP:1500
-ipfix_dev=em1
-ipfix_tcp_collectors=YOUR_QOESTOR_IP:1501
-</code>
-**You will need to restart fastdpi for the changes to take effect.**
-**Note that the netflow parameter is a bit mask. Allows several different values. For more details see here [[en:dpi:dpi_options:opt_statistics:statistics_settings:start|Configuring IPFIX export]]**
-Also you can do customization using DPIUI2 - [[en:dpi:dpi_components:dpiui:start|dpiui2 ]]. Dpiui2 version must be at least 2.1.0.
-To configure using DPIUI2, go to DPI Control -> Configuration. Open the Collect and analyze statistics by protocols and directions tab.
-Set the neflow parameter to Export full session statistics. See fig. below.
-{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi.png?400 |}}
-Enter the receiver's fullflow socket in the netflow_full_collector parameter. The netflow_full_collector_type parameter must be set to "Export ipfix to udp collector" and leave the netflow_full_port_swap parameter empty or equal to "Keep original port numbers". See fig. below.
-{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_1.png?400 |}}
-Enter the receiver's clickstream socket in the ipfix_udp_collectors parameter. See fig. below.
-{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_2.png?400 |}}
-Click Save. Restart fast_dpi. See fig. below.
-{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_save_restart.png?400 |}}
-== Assigning a DPI number ==
-Open the Hardware Management -> Hardware section. For each device, enter an Id on the ipfix collector. See fig. below.
-{{ :dpi:dpi_components:qoestor:qoestor_конфигурация_dpi_set_dpi_num.png?400 |}}
-=== Configuring DPIUI2 connection to QoE Stor ===
-To view QoE reports, you need to configure DPIUI2 connection to QoE Stor. See section [[en:dpi:dpi_components:dpiui:configuration:start|Configuring connection to QoE Stor]]

Profile

Settings

Differences