Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:dpi:dpi_components:platform:dpi_config [2025/07/24 11:30] – [dpdk_engine=6: RSS dispatchers per bridge] elena.krasnobryzh | en:dpi:dpi_components:platform:dpi_config [2026/03/02 14:28] (current) – [Ports configuration] elena.krasnobryzh | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| ===== Ports configuration ===== | ===== Ports configuration ===== | ||
| + | |||
| + | <note important> | ||
| + | Please note that Mellanox network interface cards cannot be switched to DPDK using the driverctl utility — their driver is installed in a different way. They also remain under operating system control, therefore the interfaces will still appear in the output of ip/ipconfig utilities. | ||
| + | If it is necessary to install a driver to support DPDK on Mellanox network cards, please [[en: | ||
| + | </ | ||
| The network cards that Stingray will work with are removed from the control of the operating system and therefore are not visible as Ethernet devices to the operating system. | The network cards that Stingray will work with are removed from the control of the operating system and therefore are not visible as Ethernet devices to the operating system. | ||
| Line 379: | Line 384: | ||
| This example creates 24 dispatcher threads — 4 dispatchers per bridge. | This example creates 24 dispatcher threads — 4 dispatchers per bridge. | ||
| - | <note tip> | + | <note tip> |
| + | Total number of dispatchers = '' | ||
| + | For 100G+ NICs, with a ratio of 1 dispatcher per 10G, the minimum number of dispatchers is 10.\\ | ||
| + | Starting from version 14.0, the maximum number of dispatchers is 32. | ||
| + | </ | ||
| On-stick devices are supported.\\ | On-stick devices are supported.\\ | ||