Differences

This shows you the differences between two versions of the page.

--- en:dpi:dpi_components:platform:dpi_config:start [2018/04/10 13:07] – kvazikrav
+++ en:dpi:dpi_components:platform:dpi_config:start [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== 3 Configuration ======
-{{indexmenu_n>3}}
-DPI platform is configured by the file /etc/dpi/fastdpi.conf.
-==Configuring network interfaces to use:==
-The interfaces are configured by pairs "input" - "output". For further convenience we consider that "input" faces the internal network and "output" faces uplink. Each pair forms a network bridge. It is transparent on L2 level. The interfaces available for configuring have names in format dna<digit>.
-==Example 1==
-To create the following pairs, or bridges:\\
-dna0 <--> dna1\\
-dna2 <--> dna3\\
-dna4 <--> dna5\\
-<code>
-in_dev=dna0:dna2:dna4
-out_dev=dna1:dna3:dna5
-</code>
-==Example 2==
-The complete DPI configuration file to perform filtering by Federal Supervision Agency for Information Technologies and Communications and Department of Justice lists:
-<code>
-in_dev=dna0
-out_dev=dna1
-federal_black_list=true
-</code>
-During the system installation other important system settings could be made. It should not be deleted, and is subject to change only if you understand the consequences of what you are doing. Here are some of them:
-<code>
-#Scale factor is about 1 for every 1 Gigabit of bandwidth
-scale_factor=10
-timeout_check_dev=0
-#FDPI Control
-ctrl_port=29000
-ctrl_dev=lo
-#Turn on UDP detection
-only_tcp=0
-#Turn on UDR
-udr=1
-</code>
-Other configuration parameters deal with specific options and are placed in [[en:dpi:dpi_options:start|respective directories]].
-Notes:\\
-in_dev and out_dev - are the "cold" parameters\\
-federal_black_list - is the "hot" parameter\\
-Please check the chapter [[en:dpi:dpi_components:platform:dpi_admin:start|administration]] for details.

Profile

Settings

Differences