Differences

This shows you the differences between two versions of the page.

--- en:dpi:dpi_brief:test_cases:nat [2025/05/26 14:44] – [3. Creating a reverse route (GUI)] elena.krasnobryzh
+++ en:dpi:dpi_brief:test_cases:nat [2025/05/26 14:45] (current) – [3. Creating a reverse route (GUI)] elena.krasnobryzh
@@ Line 128: / Line 128: @@
 In the same section “DPI/Services”, CGNAT tab.\\
 In the right column "Subscribers", add a subscriber, select the "Unbound" type, enter the subscriber’s IP, select service 11 “CGNAT” or “NAT 1:1”, check the box "Yes" to enable, select the profile, click "Apply" and "Save".\\ {{:en:dpi:dpi_brief:test_cases:nat_img4.png?nolink&500|}}
 ====3. Creating a reverse route (GUI)====
+To route reverse traffic to the NAT pool towards the subscribers, it will be necessary to create a route to the NAT pool on the router after the SSG and make this route known to the other routers in the network. The process is the same as in Test 1. The steps and commands do not change.
 ====4. Checking traffic flow and interface orientation (GUI)====
 In the GUI, navigate to DPI > Statistics > NAT Statistics\\ {{:en:dpi:dpi_brief:test_cases:nat_img5.png?nolink&800|}}\\

Profile