Appliance installation instruction [Документация VAS Experts]
Документация VAS Experts Документация VAS Experts-mobile
in

Settings

  • Show page
  • Old revisions
  • Fold/unfold all
  • Backlinks
  • Show page
  • Old revisions
  • Fold/unfold all
  • Backlinks

    • Differences

    This shows you the differences between two versions of the page.

    Link to this comparison view

    Both sides previous revisionPrevious revision
    en:dpi:dpi_brief:network_preparation:install_point_ssg:micra_install [2024/12/12 07:38] – удалено - внешнее изменение (Дата неизвестна) 127.0.0.1en:dpi:dpi_brief:network_preparation:install_point_ssg:micra_install [2024/12/12 07:38] (current) – ↷ Страница перемещена из en:dpi:dpi_brief:install_point_ssg:micra_install в en:dpi:dpi_brief:network_preparation:install_point_ssg:micra_install elena.krasnobryzh
    Line 1: Line 1:
     +====== Appliance installation instruction ======
     +{{indexmenu_n>2}}
      
     +A typical connection diagram for **x86 server hardware**:
     +
     +{{ dpi:dpi_brief:install_point_ssg:equipment_scheme.png?nolink&1200 |}}
     +
     +Cards with [[en:dpi:dpi_brief:dpi_requirements#minimum_requirements|10/25/40/100 network ports]] are placed in **slots 1-10**\\
     +Each slot has a unique PCIe bus identifier, e.g. **02:00**.\\
     +Each port has a unique identifier on the card, e.g: **02:00.0, 02:00.1, 02:00.2, 02:00.3**.\\
     +
     +**Example of interfaces orientation in pairs:**
     +<code>
     +   # In, to the subscriber side - port 02:00.0, 02:00.2
     +in_dev=02:00.0:02:00.2
     +   # Out, to the Internet side - port 02:00.1, 02:00.3
     +out_dev=02:00.1:02:00.3
     +</code>
     +
     +Port configuration is described in the section [[en:dpi:dpi_components:platform:dpi_config|DPDK Interfaces Configuration]].
     +
     +Ports **mg0, mg1** are used for SSH management, IPFIX sending (Full flow, NAT log, ClickStream), integration with Radius/PCRF . For fault tolerance, they are combined in LAG.
     +
     +The **bmc** port is used to connect to the BMC server controller.
     +
     +Each server has two power supplies **psu1, psu2** for power redundancy.