Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
en:dpi:dpi_brief:network_preparation:install_point_ssg:instruction_instal [2024/12/12 07:38] – удалено - внешнее изменение (Дата неизвестна) 127.0.0.1 | en:dpi:dpi_brief:network_preparation:install_point_ssg:instruction_instal [2024/12/12 07:38] (current) – ↷ Страница перемещена из en:dpi:dpi_brief:install_point_ssg:instruction_instal в en:dpi:dpi_brief:network_preparation:install_point_ssg:instruction_instal elena.krasnobryzh | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Base SSG configuration for INLINE scheme ====== | ||
+ | {{indexmenu_n> | ||
+ | - Prepare the server according to the [[en: | ||
+ | - Install and configure the [[en: | ||
+ | - Set an [[en: | ||
+ | - Apply for license installation and fastDPI to [[en: | ||
+ | - After installing them, the following settings must be made in **'' | ||
+ | * Set up transit: <code bash> | ||
+ | in_dev=01: | ||
+ | out_dev=01: | ||
+ | #Scale factor is about 1 for every 1 Gigabit of bandwidth | ||
+ | scale_factor=10 | ||
+ | timeout_check_dev=0 | ||
+ | |||
+ | #FastDPI Control | ||
+ | ctrl_port=29000 | ||
+ | ctrl_dev=lo | ||
+ | |||
+ | #Turn on UDR | ||
+ | udr=1 | ||
+ | </ | ||
+ | * Statistics gathering: <code bash> | ||
+ | # | ||
+ | netflow=8 | ||
+ | netflow_full_collector_type=2 | ||
+ | netflow_dev=eth3 | ||
+ | netflow_timeout=20 | ||
+ | netflow_full_collector=172.18.254.124: | ||
+ | netflow_rate_limit=30 | ||
+ | netflow_passive_timeout=40 | ||
+ | netflow_active_timeout=120 | ||
+ | |||
+ | # | ||
+ | ipfix_dev=eth3 | ||
+ | ipfix_tcp_collectors=172.18.254.124: | ||
+ | |||
+ | #SIP | ||
+ | ipfix_meta_tcp_collectors=172.18.254.124: | ||
+ | rlimit_fsize=32000000000</ | ||
+ | - Further settings are made depending on which components are to be used. The settings are described in the [[en: |