Appliance installation instruction [Документация VAS Experts]

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
en:dpi:dpi_brief:install_point_ssg:micra_install [2023/08/28 14:37] – ↷ Операцией перемещения обновлены ссылки elena.krasnobryzhen:dpi:dpi_brief:install_point_ssg:micra_install [2025/05/23 14:02] (current) – ↷ Page moved from en:dpi:dpi_brief:network_preparation:install_point_ssg:micra_install to en:dpi:dpi_brief:install_point_ssg:micra_install elena.krasnobryzh
Line 13: Line 13:
 <code> <code>
    # In, to the subscriber side - port 02:00.0, 02:00.2    # In, to the subscriber side - port 02:00.0, 02:00.2
-in_dev=02:00.0|02:00.2+in_dev=02:00.0:02:00.2
    # Out, to the Internet side - port 02:00.1, 02:00.3    # Out, to the Internet side - port 02:00.1, 02:00.3
-out_dev=02:00.1|02:00.3+out_dev=02:00.1:02:00.3
 </code> </code>
  
-Port configuration is described in the section [[en:dpi:dpi_components:platform:dpi_config:start|DPDK Interfaces Configuration]].+Port configuration is described in the section [[en:dpi:dpi_components:platform:dpi_config|DPDK Interfaces Configuration]].
  
 Ports **mg0, mg1** are used for SSH management, IPFIX sending (Full flow, NAT log, ClickStream), integration with Radius/PCRF . For fault tolerance, they are combined in LAG. Ports **mg0, mg1** are used for SSH management, IPFIX sending (Full flow, NAT log, ClickStream), integration with Radius/PCRF . For fault tolerance, they are combined in LAG.