Base SSG configuration for ON-STICK scheme [Документация VAS Experts]
Документация VAS Experts Документация VAS Experts-mobile
in

Settings

  • Show page
  • Old revisions
  • Fold/unfold all
  • Backlinks
  • Show page
  • Old revisions
  • Fold/unfold all
  • Backlinks

    • Differences

    This shows you the differences between two versions of the page.

    Link to this comparison view

    Both sides previous revisionPrevious revision
    en:dpi:dpi_brief:install_point_ssg:instruction_instal_onstick [2025/05/23 14:02] – removed - external edit (Unknown date) 127.0.0.1en:dpi:dpi_brief:install_point_ssg:instruction_instal_onstick [2025/05/23 14:02] (current) – ↷ Page moved from en:dpi:dpi_brief:network_preparation:install_point_ssg:instruction_instal_onstick to en:dpi:dpi_brief:install_point_ssg:instruction_instal_onstick elena.krasnobryzh
    Line 1: Line 1:
     +====== Base SSG configuration for ON-STICK scheme ======
     +{{indexmenu_n>4}}
     +<note>Full description of on-stick mode in [[en:dpi:dpi_components:platform:dpi_inst_spec:dpi_onstick]] section </note>
     +  - Prepare the server according to the [[en:dpi:dpi_brief:dpi_requirements|installation requirements]].
     +  - Install and configure the [[en:veos:first_install:ipsetincenos|VEOS OS]]
     +  - Set an [[en:veos:first_install:ipsetincenos|IP address]].
     +  - Apply for license installation and fastDPI to [[en:dpi:techsupport_info|Service Desk]].
     +  - After installing them, the following settings must be made in **''etc/dpi/fastdpi.conf''**:<code bash>dpdk_device=port1:pci:86:00.0
     +dpdk_device=port2:pci:86:00.1
      
     +lag {
     +    name=LACP
     +    device=86-00.1
     +    device=86-00.0
     +    lacp=1
     +    system_id=6c:b3:11:60:fa:66
     +    priority=32768
     +    balance_algo=0
     +}
     +
     +onstick_device {
     +    base=port1
     +    filter=vlan(101,102) | qinq
     +    subs=subs1
     +    inet=inet1
     +}
     +
     +onstick_device {
     +    base=port2
     +    filter=vlan(101,102) | qinq
     +    subs=subs2
     +    inet=inet2
     +}
     +
     +in_dev=subs1:subs2
     +out_dev=inet1:inet2</code>
     +  - Further settings are made depending on which components are to be used. The settings are described in the [[en:dpi:dpi_components|]] section.
     +
     +=====Implementation scheme=====
     +{{ :en:dpi:dpi_components:platform:dpi_inst_spec:dpi_onstick:onstick.png?nolink&550 |}}