Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:dpi:dpi_brief:install_point_ssg:instruction_instal_onstick:start [2024/03/28 12:24] – elena.krasnobryzh | en:dpi:dpi_brief:install_point_ssg:instruction_instal_onstick:start [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== The SSG installation manual using on-stick installation scheme ====== | ||
| - | {{indexmenu_n> | ||
| - | - Prepare the server according to the [[en: | ||
| - | - Install and configure the [[en: | ||
| - | - Set an [[en: | ||
| - | - Apply for license installation and fastDPI to [[en: | ||
| - | - After installing them, the following settings must be made in **'' | ||
| - | dpdk_device=port2: | ||
| - | |||
| - | lag { | ||
| - | name=LACP | ||
| - | device=86-00.1 | ||
| - | device=86-00.0 | ||
| - | lacp=1 | ||
| - | system_id=6c: | ||
| - | priority=32768 | ||
| - | balance_algo=0 | ||
| - | } | ||
| - | |||
| - | onstick_device { | ||
| - | base=port1 | ||
| - | filter=vlan(101, | ||
| - | subs=subs1 | ||
| - | inet=inet1 | ||
| - | } | ||
| - | |||
| - | onstick_device { | ||
| - | base=port2 | ||
| - | filter=vlan(101, | ||
| - | subs=subs2 | ||
| - | inet=inet2 | ||
| - | } | ||
| - | |||
| - | in_dev=subs1: | ||
| - | out_dev=inet1: | ||
| - | - Further settings are made depending on which components are to be used. The settings are described in the [[en: | ||
| - | |||
| - | =====Implementation scheme===== | ||
| - | {{ : | ||