Differences

This shows you the differences between two versions of the page.

--- en:dpi:dpi_brief:install_point_ssg:instruction_instal_onstick:start [2024/02/02 08:47] – created elena.krasnobryzh
+++ en:dpi:dpi_brief:install_point_ssg:instruction_instal_onstick:start [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== The SSG installation manual using on-stick installation scheme ======
-{{indexmenu_n>4}}
-  - Prepare the server according to the [[en:dpi:dpi_brief:dpi_requirements:start|installation requirements]].
-  - Install and configure the [[en:veos:first_install:ipsetincenos|VEOS OS]]
-  - Set an [[en:veos:first_install:ipsetincenos|IP address]].
-  - Apply for license installation and fastDPI to [[en:dpi:techsupport_info:start|Service Desk]].
-  - After installing them, the following settings must be made in **''etc/dpi/fastdpi.conf''**:<code bash>dpdk_device=port1:86:00.0
-dpdk_device=port2:86:00.1
-lag {
-    name=LACP
-    device=86-00.1
-    device=86-00.0
-    lacp=1
-    system_id=6c:b3:11:60:fa:66
-    priority=32768
-    balance_algo=0
-}
-onstick_device {
-    base=port1
-    filter=vlan(101,102) | qinq
-    subs=subs1
-    inet=inet1
-}
-onstick_device {
-    base=port2
-    filter=vlan(101,102) | qinq
-    subs=subs2
-    inet=inet2
-}
-in_dev=subs1:subs2
-out_dev=inet1:inet2</code>
-  - Further settings are made depending on which components are to be used. The settings are described in the [[en:dpi:dpi_components:start|]] section.

Profile