Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |
| en:dpi:bras_bng:radius_integration:radius_accounting:setup [2024/12/05 15:08] – elena.krasnobryzh | en:dpi:bras_bng:radius_integration:radius_accounting:setup [2025/04/29 07:39] (current) – elena.krasnobryzh |
|---|
| * 1 - since the Start event.\\ When the ''acct_start_point=0'' is used within the ''acct_check_idle_mode=1'' mode all the "parasite" traffic being accumulated since the last Stop event will fall into new accounting session.\\ When the ''acct_start_point=1'' is used instead all the "parasite" traffic being accumulated since the last Stop event will be ignored.\\ Also, due to the time delays between accounting "activating" and the actual netflow statistics gathering, the outgoing traffic statistics may be slightly distorted (downwards). | * 1 - since the Start event.\\ When the ''acct_start_point=0'' is used within the ''acct_check_idle_mode=1'' mode all the "parasite" traffic being accumulated since the last Stop event will fall into new accounting session.\\ When the ''acct_start_point=1'' is used instead all the "parasite" traffic being accumulated since the last Stop event will be ignored.\\ Also, due to the time delays between accounting "activating" and the actual netflow statistics gathering, the outgoing traffic statistics may be slightly distorted (downwards). |
| |
| * ''acct_auth_sync'' - [SSG 8.1+] authorization and account synchronization. Disabled by default (no synchronization). Some billing systems (e.g. LanBilling) require the current account session to be closed before sending an Access-Request.\\ The ''acct_auth_sync=1'' setting synchronizes the accting and authorization: when an auth-request arrives, the SSG closes the current acct session (sends acct Stop), waits for a response from Radius to acct Stop, and only then sends an Access-Request auth-request with the new acct sessionId. In addition, [SSG 9.2+] when closing an account session by idle timeout PCRF sends a notification to SSG about session closure; in this case SCAT resets the authorization status, which further leads to subscriber reauthorization - sending ''Access-Request''. | * ''acct_auth_sync'' - [SSG 8.1+] authorization and account synchronization. Disabled by default (no synchronization). Some billing systems (e.g. LanBilling) require the current account session to be closed before sending an Access-Request.\\ The ''acct_auth_sync=1'' setting synchronizes the accting and authorization: when an auth-request arrives, the SSG closes the current acct session (sends acct Stop), waits for a response from Radius to acct Stop, and only then sends an Access-Request auth-request with the new acct sessionId. In addition, [SSG 9.2+] when closing an account session by idle timeout PCRF sends a notification to SSG about session closure; in this case SSG resets the authorization status, which further leads to subscriber reauthorization - sending ''Access-Request''. |
| |
| * ''acct_disable_interim_update'' - prohibiting the sending of Interim-Updates. | * ''acct_disable_interim_update'' - prohibiting the sending of Interim-Updates. |
| * ''acct_disable_interim_update=0'' — by default, Interim-Update is sent | * ''acct_disable_interim_update=0'' — by default, Interim-Update is sent |
| * ''acct_disable_interim_update=1'' — do not send an Interim-Update | * ''acct_disable_interim_update=1'' — do not send an Interim-Update |
